GE DFE Série Manuel D'utilisation Et Instructions D'installation page 46

Masquer les pouces Voir aussi pour DFE Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting Tips... Before you call for service
Problem
Water spurting from dispenser*
No water or ice cube production*
Water is leaking from dispenser*
AUTO FILL
AUTO FILL overfills*
ing
Low brewing flow rate
from inner door
Brewer is not detected or hot water
leaking from top of the brewer
Coffee dispensed with splash or
bubble bursting
*Select Models Only
46
Possible Causes
Newly installed filter cartridge
Supply line or shutoff valve is
clogged
Water filter is clogged
Air may be present in the water line
system, causing water to drip after
being dispensed
Not all containers work with
AUTOFILL
Error message
Not all containers work with
AUTO FILL
-
Normal, when refrigerator first
plugged in or after extended power
outage
Normal
There may have been a dent at the
to pierce the filter allowing coffee
grounds clogging the bottom pin
Top needle of the brewer clogged
bracket
Blocked vent hole in the brewer
What to Do
Run water from the dispenser for 5
Call a plumber
Replace filter cartridge or remove filter
and install bypass plug**
Remove and reinstall filter cartridge,
being certain that it locks in place.
Check that the ice maker is turned on.
See About the Automatic Ice Maker.
remove air from system
Try different container
See page 14
Clean sensor. See page 14.
Try different container
Wait 24 hours for temperature in both
compartments to reach selected
temperatures.
The ice dispenser door may open after
and clean the lower needle before next
brew
paper clip and rinse brewer. Rinse
brewer after every use.
front. Push brewer all the way in the
brackets
Make sure the vent hole at the bottom
of the brewer is clear from food or any
other contamination
49-60792-1

Publicité

Table des Matières
loading

Table des Matières