Cuda surgical ELITE 9000-II Guide De L'utilisateur page 9

If fuel gauge recalibration is needed, the red LED on a calibrating charger will
flash upon insertion of the battery. This provides feedback on the accuracy of the
fuel gauge and avoids unnecessary calibration cycles.
The user can either calibrate the fuel gauge and charge the battery, or just charge the
battery.
Calibration takes longer than charging and it may not be convenient to go through the
calibration cycle.
To recalibrate the fuel gauge, press the button on the front of the charger.
The charger will automatically begin to charge the battery if the button is not pressed.
The blue LED will flash to indicate that the battery is undergoing the recalibration cycle.
During calibration the discharge resistors will be cooled by the fan. Removing the
battery, or pressing the calibration button again will re-start the process from the
beginning.
At the end of this procedure the blue LED will stay constant indicating a fully calibrated
fuel gauge. Warm environments can cause calibration failure - keep the charger away
from direct sunlight or heat sources.
7. REPLACEMENT PARTS
For replacement parts, additional or optional equipment :
Please call Customer Service @ 877-677-2832
8. USER SERVICE
The LED Headlight has no user or field serviceable components. It can only be serviced
at the factory by factory trained technicians.
9. LIMITED WARRANTY
Your LED Headlight and battery holster carry a three year warranty from the date of
shipment on workmanship and all defects of material.
Your batteries and charger carry a one year warranty from the date of shipment on
workmanship and all defects of material. Should your product prove to have such
defects ST Technologies will repair or replace the product or component part without
charge. Please contact ST Technologies for return authorization documentation.
You should carefully pack unit in a sturdy carton and ship it to the factory. Please
include a note describing the defects, your name, telephone number and a return
address. Warranty does not cover equipment subject to misuse, accidental damage,
normal wear and tear or if transferred to a new owner without authorization from ST
Technologies. This warranty gives you specific legal rights and you may also have
other rights that vary from state to state.
®
LIT-224 CUDA
(English)
Rev. -
Date of Revision: 08/07/17
Page 9 of 53