Bauknecht DWGR 7881 ES Manuel D'utilisation Et D'entretien page 13

MAINTENANCE
ATTENTION:
GREASE FILTERS
The metal grease filter has an unlimited life and should be cleaned once a month by hand or in a dishwasher at low
temperature and with a short cycle. Cleaning in a dishwasher may cause discoloring of the grease filter, but its
filtering efficiency is unaffected.
Open the extraction panel (twist upwards).
Note: the panel does not need to be removed.
Pull out the handle to remove the filter.
Wash the filter and leave it to dry, proceeding in reverse order to refit.
CARBON FILTER (filter hoods only)
It retains the unpleasant odors produced during cooking.
Change the carbon filter every 4 months
Fitting or changing the carbon filter
1. Disconnect the hood from the power supply.
2. Open the extraction panel and remove it.
3. Remove the grease filters.
4. Fit one carbon filter each side, covering both protection grilles of the motor impeller.
Turn the filters clockwise to secure them to the middle pins.
Proceed in reverse order to remove.
Re-fit the grease filters and extraction panel.
REPLACING LAMPS
The hood lighting system is based on LED technology.
The LEDs provide optimal illumination, with a lifetime up to ten times longer than traditional lamps but with
90% less energy consumption.
To replace them, proceed as follows:
1. Remove the grease filters.
2. Access the lamps inside the hood.
3. Press the release springs to unfasten the lamp.
4. Take the lamp out of the hood.
5. Disconnect the electrical terminal.
Fit the replacement lamp by performing the above steps in reverse.
N.B.: To purchase replacement LED lamps, contact the technical support service.
- use protective gloves.
- disconnect the appliance from the power supply.
GB11