CLAS OP 4508 Mode D'emploi page 6

OP 4508
PNEUMATIC BRAKE CALIPER REWIND TOOL
OPERATING INSTRUCTIONS
1. Select a suitably sized, pinned adapter (Fig. 1).
2. Connect the adapter to the magnetic pins on the pneumatic tool nozzle.
3. Connect the pneumatic tool to the workshop air supply.
4. Press pressure release button and turn rotary lever to set length.
5. Fit pneumatic tool to brake caliper.
6. Press the feed button to secure the tool to the brake caliper (Fig. 2 and 3).
7. Make sure the tool is securely installed on the brake caliper.
8. Continuously press the power button and turn the rotating lever to wind up the brake piston.
Once the piston is in the correct position, press the pressure release button to remove the
pneumatic tool from the brake caliper.
Fig. 1
• Always read the instructions carefully before using the tool.
• Ensure that the work area is adequately lit.
• Keep children and unauthorized persons away from the work area.
• Keep the work area clean and tidy, dry and free of extraneous materials.
• DO NOT allow untrained persons to use this tool kit.
• Always wear eye protection complying with OSHA and ANSI Z87.1
standards.
• Always wear gloves when working with the tool.
• Always wear hearing protection.
• Disposal: Customers must follow local regulations for handling used/
destroyed parts.
Fig. 2 Fig. 3