Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Apply sealant into the (2) screw holes. See
(FIG. 5).
10. Assemble the selected gasket to the outside
lock unit, aligning holes of gasket with holes of
lock unit. See (FIG. 5).
N OTE: Incorrect gasket selection or orien-
tation may result in water leakage.
FIG. 5
Apply sealant
11. Assemble outside lock unit, with gasket, to
mounting location, ensuring breather slot is fac-
ing downward. See (FIG. 5).
12. Assemble small gasket to inside lock unit, align-
ing holes of gasket with holes of lock unit. See
(FIG. 6).
FIG. 6
Long
Plug
13. Assemble inside lock unit, with gasket, to out-
side lock unit, aligning with square shafts. See
(FIG. 6).
W hen assembling, with key removed and
locking plate locked into any position, align
cut-out of thumb turn with screw hole, and
align long lobe of inside lever the same
direction as locking plate. See (FIG. 7).
Slot
Short
FIG. 7
Locking Plate
Inside Lever
Thumb Turn
Screw Hole
14. Secure units with (1) short and (1) long screw.
Note location of each. See (FIG. 6).
NOTE: Hand tighten screws.
15. Apply (2) plugs to holes, covering screws. See
(FIG. 6).
16. Installation is now complete.
4
Publicité
