Publicité
Les langues disponibles
Les langues disponibles
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed under a custom counter, or in a
basement, laundry room, closet, or recessed area. See "Drain
System."
Companion appliance location requirements should also be
considered.
Proper installation is your responsibility.
You will need
•
A water heater set to deliver 120°F (49°C) water to the
washer.
•
A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
•
Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6
kPa).
•
A level floor with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
•
A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 Ibs (180 kg).
Do not operate your washer in temperatures
below 32°F (O°C).
Some water can remain in the washer and can cause damage in
low temperatures.
Installation
clearances
•
The location must be large enough to allow the washer door
to be fully opened.
•
Additional spacing should be considered for ease of
installation and servicing. The door opens more than 90 °, and
it is not reversible.
•
Additional clearances might be required for wall, door, and
floor moldings.
•
Additional spacing of 1" (2.5 cm) on all sides of the washer is
recommended
to reduce noise transfer.
•
Companion appliance spacing should also be considered.
Washer Dimensions
601/4"
(127.6¢m)
36"
(9!.4 cm)
Door is not reversible.
Recommended
installation
spacing for custom
undercounter
installation
The dimensions
shown are for the recommended
spacing.
Custom undercounter
installation - Washer only
(
37' mir_.
(93.9 cm}
1" _F%,, 27"--._
!"
(2.5 cm}
(68,6 cm}
(2.5 cm)
Recommended
installation
spacing for recessed or
closet installation,
with or without
a pedestal
The dimensions
shown are for the recommended
spacing.
Recessed area or closet installation
_LL114,,,m0x.
--_1 1"1_-30v="-*1 4" _--
(2.6 ore} (77.5era)
(10.2cm}
A
48 ir_. 2._
(3!0 cm=)
24in,=*-
(155cm=)
A. Side view - closet or confined area
B, Closet door with vents
*Min. top and bottom air openings for closet door.
Recessed or closet installation - Washer on pedestal
1" -_41_-
27"-_4t_-
1"
(2.6 o re)
(66.6 c rn)
(2.5 era)
14"*max.
--_11'_
86v2'_1 4' I_-
(2.6 cm}
(77.6ore) (10.2cm)
A
B
A. Recessed area
B. Side view - closet or confined area
Publicité
