Garland 762 G Manuel D'instructions page 45

10. TRANSPORT
Never pick up or carry the machine while the engine
is running. It is always necessary too to turn off the
motor before transporting the machine between work
locations.
Wait five minutes after the machine has been stopped
to ensure that the machine cools down before storing
or transporting. The exhaust pipe of the machine will
remain hot after the motor shutdown.
Hold the machine by the front handle when the
machine is not running and always at a safe distance
from your body. When transporting or storing the
machine cover the blade with a blade protector. A
proper use of the machine will result in a reduced
probability of accidental damages with the cutting
elements.
If you are going to transport the machine in a vehicle,
securely fasten it to avoid the machine slipping or
tumbling over.
11. STORAGE
Once the machine has been stopped, wait for five
minutes so that the machine cools down before
storing the machine. The exhaust pipe will still be
hot after the machine has been turned off. Do not
store the machine in a place close to heat sources,
inflammable products, dry grass, wood, gases and
petrol.
Store this machine in a place not accessible to
children and secure. It should also be dry, clean and
within the temperature range 0ºC and 45ºC.
Before storing the machine follow the points of the
maintenance chapter.
Always set the blade guard.
Keep the machine in its box, on a flat surface
If you are going to store the machine in a closed area,
empty the petrol and oil deposits as vapours could
cause a fire if near inflammable products. If, the petrol
deposit has to be emptied, this must be done outdoors
and following your local recycling normative.
To reduce fire hazard, keep the engine, silencer and
petrol tank area free of cutted material and grease.
Clean the machine and the blade. After cleaning the
blade, place a small quantity of oil on the blade.
12. RECYCLING OR DISPOSAL OF
YOUR MACHINE
Get rid of your machine in an ecological
way. We should not get rid of the machine
with the domestic rubbish. Its plastic and
metallic parts can be classified and can be recycled.
All materials used to box this machine are
recyclable. Please, do not dispose of the box
with your domestic rubbish. Throw these
parts in an official ecological residual pick up point.
45/144
English