Garland 762 G Manuel D'instructions page 42

English
Use always original spare parts and accessories
so as to achieve the best performance from the
machine and to avoid damages to the end user and
the machine. The use of non original spare parts and
accessories can cause accidents, personal damages
and machine breakage.
8.2.1. PETROL FILTER
The petrol deposit is equipped with a filter. It is located
in the extreme of the aspiration petrol tube and can be
removed using a wire shaped like a hook.
Check the petrol filter periodically. Do not allow dirt to
enter the petrol deposit to avoid the filter getting dirty.
A dirty filter will difficult the engine starting and will
provoke instability and in extreme cases, the machine
might even stop.
Check the petrol. If you observe dirt, replace it.
If the interior of the petrol deposit is dirty, you can
clean it with petrol.
8.2.2. SPARK PLUG MAINTENANCE
The most common problems when starting the
machine are due to a dirty spark plug or to a spark
plug in a bad state.
Clean the spark plug and check it regularly. Check
that the distance between electrodes is correct (0.6-
0.7mm).
8.2.3. CLEANING THE CYLINDER REFRIGERATION
VENTS
The cylinder refrigeration vents are responsible for
cooling the piston and the cylinder by means of the
entry of air.
The vents must always be kept clean, free from
material that could block air from entering. Dirty vents
mean that the engine will overheat, causing it to seize.
Check and clean the cylinder vents periodically.
8.2.4. BLADE MAINTENANCE
Lubricate the blades regularly with oil.
The blades of this machine are high quality metal
and do not need to be filed. If accidentally, the blade
catches on a metallic surface, touches a rock or any
other hard object, a small breakage could occur.
If this small breakage does not impede the blades
functioning correctly, then you can carry on using the
machine. If, on the other hand, the machine does not
work properly, then take the machine to your nearest
after sales dealer.
Every two hours add grease to the blade.
8.2.5. GEAR BOX
Every twenty hours add grease to the gearbox.
42/144