Publicité
Les langues disponibles
Les langues disponibles
Installation
1
Install Unit
Rough-in of plumbing lines and wall braces must be completed
before unit can be properly installed.
Remove Access panel and
A
with the help of another
person, place unit in position
against wall.
B
Ensure unit is level, shimming floor unit if
necessary. Mark the wall anchor locations.
2
Connect Water Supply to Valve Assembly
Connect stops to hot and cold water supply.
A
Connect one end of each supply hose to a stop
and the other end to the hot and cold inlets of
the Navigator TMV.
Do not turn on water until
Step 4 is completed!
Bradley • 215-1759 Rev. A; ECN 14-00-007
Water Supply Gang
Valve Assembly
OPTIONAL TEMPERED LINE CONNECTION: Connect
B
stop to supply. Connect one end of the supply hose to the
stop and the other end to the tempered line adapter in the
gang valve assembly as shown.
Install suitable wall anchors (supplied
C
by installer) for 3/8" bolts at the marked
locations. Secure unit to wall.
Red Tube
(to Aerator)
Green Tube
(to Aerator)
Black Tube
(to Aerator)
Yellow Tube
(to Aerator)
Navigator TMV
Cold Supply Inlet
10/20/2014
SN2004/TT, SN2024/TT
Water Supply
Gang Valve
Assembly
OPTIONAL
Tempered Line
Adapter Assembly
(S39-804)
Braided
Hose
Stop Valve
Hot Supply Inlet
5
Publicité
