Publicité
Les langues disponibles
Les langues disponibles
Key
Description
A
Air hose
B
In-line Filter
C
Tee Fitting
To begin using the tool:
1.
As a standard practice, drain water from the air compressor tank
and air lines prior to use each day (reference your compressor
operators manual for detailed instructions).
2.
Install a 1/4" NPT male connector (not included) into the air inlet
port on the tool (see Figure 2). Note: Use Teflon® Tape on all
threaded connections.
3.
Turn on the air compressor and allow it to build up pressure.
4.
Adjust the air compressor's regulator or the supply line regulator to
90 PSI.
5.
Assemble the selected chisel and retainer spring to the air hammer;
a.
Insert the selected chisel into the barrel of the air hammer.
b.
Slide the retainer spring over the chisel.
c.
Screw the retainer spring onto the air hammer by pressing tab
"A" and turning until the retainer spring is tight on the hammer
(see figure 3). Note: the retainer spring and chisels are normal
wear items and should be replaced when worn. To order
replacement retainer spring or chisels, please call the number
listed on the back page of this manual.
If the chisel is not securely held in place by the
retainer spring during operation, the chisel may
come loose and cause severe personal
injury.
6.
Connect the tool to the air hose quick coupler. NOTE: It is
recommended that a whip hose with a swivel (P012-0079SP -
not included) be used to prevent twisting, kinking and
excessive wear to the air hose (ref. item "F" in figure 1 for
recommended connections).
7.
Hold the air hammer in an operating position against the work (with
chisel properly secured in place) before depressing the trigger.
Squeeze the trigger gently as required to increase or decrease air
hammer speed. Release trigger to stop tool.
Chisel MUST be held firmly against the work
surface before depressing the air hammer
trigger. If the tool is not properly positioned
against the work and/or the chisel is not properly secured in the tool before the trigger
is depressed, damage to the tool and/or the retainer spring may result. Regulate the
speed of the air hammer to control the chisel from being driven from the cylinder.
Internal damage will result if the piston strikes the cylinder wall. Remove chisel from
tool when not in use.
TYPICAL
TYPICAL
Key
Description
D
In-line Oiler
E
Air Hose
F
Whip Hose
OPERA
TING INSTRUCTIONS
OPERA
TING INSTRUCTIONS
INST
ALLA
TION
INST
ALLA
TION
Key
Description
G
Quick Coupler
H
Male Connector
I
Air Tool
Install
Remove
4 - ENG
Figure 1
Key
Description
J
Female Connector
K
Spray Gun
Figure 2
Figure 3
Publicité
