Playcore Swing-N-Slide PB 8206 Instructions D'assemblage page 37

x2
Fig. 27
[PF 3875]
1'' x 4'' x 18-1/4''
[PF 3887]
1'' x 4'' x 46-1/4''
[PF 3887] 1'' x 4'' x 46-1/4''
[PF 3875] 1'' x 4'' x 18-1/4''
1-1/4'' screw
1-1/2'' screw
2-1/2'' screw
Ladder ssembly
1. Laminate Ladder Uprights as shown in (Fig. 27).
2. Install Ladder Support Boards as shown in (Fig. 27a).
3. Attach Ladder Rungs as shown in (Fig. 27b).
Pre-Drill Note: To prevent wood from splitting, pre-drill all holes
for the Ladder Rungs. Use a 1/8'' drill bit & drill to a maximum
depth of the length of the Lag Screw used.
4. Attach ladder to tower as shown in (Fig. 27c).
[PF 3908] 2'' x 4'' x 11-7/8''
Fig. 27a
(16)
1-1/4''
screws
per side
[PF 3873] 1'' x 4'' x 14-1/8''
FLUSH
2'' Lag screw
2'' screw
(2)
2-1/2'' screws Fig. 27b
per joint
Pre-Drill
(2)
1-1/2''
screws
per joint
Fig. 27c
37
Assembly Instructions
(2)
2'' Lag
11-5/8''
screws
per rung
(5)
13-7/8''
11-5/8''
LADDER
RUNG
11-5/8''
11-5/8''
5'' 5''
(4)
2'' screws
from Top of
Deck
(3)
2-1/2''
screws
per joint