Publicité
Les langues disponibles
Les langues disponibles
CLEARANCES AND DIMENSIONS
·
Dimensions that are shown in Figure 1 must be
used. Given dimensions provide minimum
clearance. Locate electrical outlet in the shade d
area in the upper left-hand corner of the cutout.
See Figure 3.
·
Contact surface must be solid and level. Pay
special attention to the floor on whic h the
Microwave Drawer will sit. The floor of the openin g
should be constructed of plywood strong enough
to support the weight of the oven (abo ut 100
pounds ).
MICROWAVE DRAWER MEASUREMENTS
Suggested electrical
outlet location
24''
cabinet min
Figure 1
Figure 2
4''
EN-2
·
Check location where the Microwave Drawe r will
be installed for proper electrical supply
·
Your oven can be built into a cabinet or wall by
itself or under a gas or electric wall oven.
·
Be sure that the clearance of the floor be tween
the wall oven and the microwave drawer is a
minimum of 2-inches.
·
The microwave interior will easily accommodate a
9" x 13" oblong dish or a bag of microwa ve
popcorn.
Anti Tip
block
Floot must
support 100lbs
Figures 1 and 2 contain many Microwave Drawer
measurements for reference when planning the
drawer's location .This Microwave Drawer can be
installed below any electric or gas wall oven.
*Can also be installed using an electrical outlet in a n
adjacent cabinet within the area where tire provided
electrical cord can reach. Power cord access hole in
cabinet should be a minimum l
debarred of all sharp edges.
IMPORTANT
Always allow sufficient power cord
length to the electrical outlet to prevent tension Always
check electrical codes for requirements.
1/2
" diameter hole and
Publicité
