Vaisala VaiNet AP10 Guide Rapide page 7

5. After configuring all of the settings, verify the status of the access point from the home
screen. The access point should be connected to the network and the viewLinc Enterprise
Server. Installation mode should be enabled if you want to connect new data loggers to
your system.
CAUTION!
accurate time. This means that data loggers cannot connect to the access
point until it has synchronized its time with a Network Time Protocol (NTP)
server. To accomplish this, the access point must have a network
connection to one of the configured NTP servers. Connecting to the default
NTP servers requires Internet access, and network firewall must allow the
access point to connect to UDP port 123.
An NTP connection error continues to be shown while AP10 is
synchronizing time with the listed NTP servers. With access points that
have software version 4.0.0 or higher, the synchronization typically takes a
minute or two.
The access point will not turn on its radio if it does not have
7