Lightwave Link Plus L2 Mode D'emploi page 5

2
Setting up the Link Plus
2.1 Attach the Ethernet cable
Take the Ethernet cable (supplied) and connect it to
any spare available LAN port on your wireless router.
Connect the other end of the cable to the Lightwave
Link Plus' single port.
2.2 Attach the power supply
Plug in the power supply and push the Micro USB
connector into the socket on the back of the Link Plus.
The Link Plus will now enter its startup sequence and
will attempt to find a connection to the Lightwave
server. A solid amber light indicates that a connection is
being attempted, and a solid green light will show once
a connection has been established. Once the green
light appears, the Link Plus is ready to be set up on the
Lightwave Link Plus App.
All manuals and user guides at all-guides.com
2.3 Check the indicator light
The LED indicator is used to indicate the status of the
Link Plus and also to indicate if there is a problem. If
there is a problem reported, it will usually refer to an
insecure cable connection or a server connection
problem (see list on the right). If the Link Plus has already
been set up, the App will display details of any specific
problem; otherwise, please visit the support section at
www.lightwaverf.com for advice.
LED Indicator
Steady green: Status
Flashing green: Trans
Flashing green / amber: L
Steady red: Cannot cont
Need some h
support@lightwaverf.com www.lightwaverf.