Publicité
Les langues disponibles
Les langues disponibles
DRILL SAFETY WARNINGS
1.
Use auxiliary handle(s), if supplied with the
tool. Loss of control can cause personal injury.
2.
Hold
power
surfaces, when performing an operation
where the cutting accessory
hidden wiring or its own cord. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
3.
Always be sure you have a firm footing.
Be sure no one is below when using the tool
in high locations.
4.
Hold the tool firmly.
5.
Keep hands away from rotating parts.
6.
Do not leave the tool running. Operate the tool
only when hand-held.
7.
Do not touch the drill bit or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
8.
Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
Class II Construction
･
revolutions or reciprocation per minute
tool
by
insulated
may contact
GEB001-6
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
gripping
unplugged before adjusting or checking function
on the tool.
Switch action
1
013476
CAUTION:
Before plugging in the tool, always check to see
•
the switch trigger actuates properly and returns to
the "OFF" position when released.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
For Model MDP204
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop. For continuous operation, pull
the switch trigger, push in the lock button and then
release the switch trigger. To stop the tool from the
locked position, pull the switch trigger fully, then release it.
For Model MDP205
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
USD201-2
trigger. Release the switch trigger to stop. For
continuous operation, pull the switch trigger, push in the
lock button and then release the switch trigger. To stop
the tool from the locked position, pull the switch trigger
fully, then release it.
Reversing switch action (For Model MDP205)
A
B
013477
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the
position (A side) for clockwise rotation or to
4
2
1
1. Switch trigger
2. Lock button
1. Reversing
switch lever
Publicité
