Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION FOR OPTIONAL ACCESSORIES (ORDERED SEPARATELY)
HBX3-MS - Microwave Motion Sensor
1. Remove 1/2" center knockout on front face of fixture.
2. Screw HBX3-MS with silicone gasket in place until tight,
ensuring gasket indents lock-in with matching fixture indents.
3. RC02 remote required to operate.
Optional: HBX3-MS-MA and HBX3-MS-MA-L available for side
mount with aluminum reflectors.
MICROWAVE MOTION SENSOR FOR ALUMINUM REFLECTORS
HBX3-MS-MA (100-200W) & HBX3-MS-MA-L (240/300W)
1. Secure motion sensor to mounting arm with plastic nut. Attach arm to fixture using provided screw.
2. Remove 1/2" knockout from the back of the fixture junction box open to access wiring.
3. Using provided cable gland, run wiring through gland and into junction box.
4. Fasten cable gland to fixture and tighten in place to ensure a tight seal.
5. Refer to attached wiring diagram to complete connections.
6. Once wiring is complete, close junction box and fasten tight to fixture.
7. RC02 remote required to operate.
REFLECTORS
Aluminum: HBX3-REF-AL (100-200W) & HBX3-REF-AL-L (240/300W)
Prismatic: HBX3-REF-PC (100-200W) & HBX3-REF-PC-L (240/300W)
1. Attached reflectors to front face of fixture with #2 Phillips
and provided screws.
RC02 - REMOTE FOR HBX3-MS
See specification sheet for detailed instruction.
SCAN TO
DOWNLOAD
HBX3-SPIKES - BIRD SPIKES
1. Attached bird spikes to back of fixture with #2 Phillips and provided screws.
2. Arrange as desired.
4
©2022 EiKO Global, LLC. World Headquarters: 18000 W. 105
Head Office, Canada: 80-86 Carrier Drive Toronto, ON Canada M9W 5R1 (P) 1.888.741.2673 (F) 1.888.705.1335
Prismatic Cone Lens: HBX3-REF-CL (100-300W)
1. Prismatic reflector required. Either HBX2-REF-PC or HBX2-REF-PC-L.
2. With prismatic reflector installed, open the ends of the circular steel
channel and place around both the cone lens flange and flange of the
prismatic reflector.
3. To secure, attach the provided spring to the circular steel channel.
WIRE GUARDS
HBX3-WG (100-200W) & HBX3-WG-L (240/300W)
1. Attached wire guard front face of fixture with #2 Phillips
and provided screws.
Note: Wire guard can be installed in combination with
reflectors.
Street, 3
Floor, Olathe, KS 66061 (P) 1.800.852.2217 (F) 1.800.492.8975
th
rd
eiko.com
Rev. 12/20/22
Publicité
