Publicité
Les langues disponibles
Les langues disponibles
HOOK OR EYEBOLT & CHAIN MOUNT
CONDUIT MOUNT
Top of fixture includes 1/2" NPS
1
mount.
Optional: For 3/4" NPS mount,
HBX3-34NPS adaptor is available.
Connect to power supply as per
5
included wiring diagram.
YOKE MOUNT
HBX3-YK (100-200W) & HBX3-YK-L (240/300W)
Mark and drill holes into surface to
1
match yoke.
With provided 10' of wire, connect
4
to power supply and dimming as
per included wiring diagrams.
2
©2022 EiKO Global, LLC. World Headquarters: 18000 W. 105
Remove safety set screw. Screw
1
included hook or optional
HBX3-EYEBOLT into top of fix-
ture, ensuring gasket remains in
place between fixture and hook/
eyebolt. Use wrench to tighten
hook. Tighten fixture safety set
screw to secure hook/eyebolt.*
Hang the luminaire with hook
2
or eyebolt and carabiner on
suspended hanging chain. Close
safety set screw on threads to
secure.
Remove safety set screw and
2
attach conduit per all local elec-
trical and safety regulations to
maintain environment rating as
required. For wet locations, ensure
liquid-tight connectors are used.
Hinge fixture closed and screw
6
junction box tightly to fixture.
Attach yoke to the luminaire with
2
provided yoke hardware. If mount-
ing hardware does not allow for
tightening with yoke attached, at-
tach fixture to yoke once secured
to surface (after step 3).
Turn power on, and test luminaire.
5
Head Office, Canada: 80-86 Carrier Drive Toronto, ON Canada M9W 5R1 (P) 1.888.741.2673 (F) 1.888.705.1335
*Note: ensure fixture safety set screw is loosened when attaching or removing hook or eyebolt. Failure
to do so can strip the threads and prevent a secure fit.
Ensure the set-screws are
3
tightened on the fixture and
adaptor if used.
Turn power on, and test
7
luminaire.
Street, 3
Floor, Olathe, KS 66061 (P) 1.800.852.2217 (F) 1.800.492.8975
th
rd
With provided 10' of wire, connect to pow-
3
er supply and dimming as per included
wiring diagrams.
Turn power on, and test luminaire.
4
With a #2 Phillips screwdriver,
4
loosen the two junction box
screws to unhinge the fixture
and open the junction box.
Insert mounting hardware loosely
3
to allow keyholes on yoke to slide
in place. Once yoke in place tight-
en mounting hardware to secure
yoke to surface.
1/2" NPS
eiko.com
Rev. 12/20/22
Publicité
