NEC Mitsubishi Diamond Plus 230SB Manuel De L'utilisateur page 7

Tools 2
Language: OSM controls menus are available in six languages.
OSM Position: You can choose where you would like the OSM controls
menu to appear on your screen. Selecting OSM Position allows you to
manually adjust the OSM controls menu left, right, up or down.
OSM Turn Off: The OSM controls menu will stay on as long as it is in
use. In the OSM Turn Off sub-menu, you can select how long the
monitor waits after the last touch of a button for the OSM controls
menu to disappear. The preset choice is in 5 seconds step between 5–
120 seconds.
OSM Lock Out: This control completely locks out access to all OSM
controls functions except Brightness and Contrast. When attempting to
activate OSM controls while in the lock out mode, a screen will appear
indicating that OSM controls are locked out. To activate the OSM Lock
Out function, press SELECT, then press + and hold down
simultaneously. To deactivate the OSM Lock Out, press SELECT, then
press + and hold down simultaneously.
IPM System Off Mode:
Enable: The IPM System works normally and all stages of energy
savings are utilised.
Disable: The Off Mode of the IPM System is not used.
NOTE: For standard systems and graphics boards, keep the factory
setting at ENABLE.
NOTE: Don't keep the monitor on when 'No Signal' is applied.
This could cause image burn in on the screen due to the 'No Signal'
message being displayed.
EdgeLock Control: Operating your monitor at a non-standard timing
may cause images to appear darker than normal or have colour
distortion. Use of the EdgeLock control will adjust images to their
normal state.
Hot Key: This selection allows you to use
and –/+ as contrast control.
Factory Preset: Selecting Factory Preset allows you a reset most
OSM control settings back to the factory settings. A warning statement
will appear to confirm that you do want to reset ALL settings. Individual
settings can be reset by highlighting the control to be reset and
pressing the RESET button.
Information
Display Mode: Indicates the current mode and frequency setting of the
monitor.
Monitor Info: Indicates the model and serial numbers of your monitor.
Refresh Notifier: A message will advise you if the refresh rate of the
signal being applied to the monitor by the computer is too low. For
further information, please refer to your display card or system manual.
01_English
Get user manuals: See SafeManuals.com
/ as brightness control
3
Declaration of the Manufacturer
We hereby certify that the colour monitor
Diamond Plus 230 SB
Council Directive 73/23/EEC:
– EN 60950
Council Directive 89/336/EEC:
– EN 55022
– EN 61000-3-2
– EN 61000-3-3
– EN 55024
and marked with
NEC-Mitsubishi Electric Visual
Systems Corporation
4-13-23, Shibaura,
Tokyo 108-0023, JAPAN
English-3
08/05/2002, 15:34
is in compliance with
Minato-Ku