Norwood LumberMate LM30 Instructions page 10

EN–4
LM29V2-LDKIT-INST (2021-09-02).indd 4 LM29V2-LDKIT-INST (2021-09-02).indd 4
Install the log dog bar (94a) to the log
dog mounting bracket (95b). Use the
1/2 x 2 1/4" hex bolts (5b) and 1/2" nyloc
nuts (1d). Tighten these.
TIP: The log dog travel stop has two
positions.
»
The lowest one is used when loading a
log onto the bed to prevent damaging it
or to simply keep the log dog below the
cross bunks.
»
The highest position is used to stop
the log dog clamp just above the cross
bunks (below 1"). It simplifies clamping
of a squared log.
Install the log dog clamp block (93) to
the log dog clamping handle (96). Use
the 1/4" hitch pin (93b).
2021-10-19 10:43:14 AM 2021-10-19 10:43:14 AM