europool HPN10V Manuel D'instructions page 40

HPN10V
Regulation (digital controller)
ON / OFF
Button
or OFF, it may take up to a few minutes to activate or deactivate.)
Working modes
Button
To choose the working mode, press this button till the corresponding LED on the display is
lighting up.
• Auto : Automatic heating and cooling mode.
Maintains the temperature of the water between heating temperature setting and cooling
temperature setting (+ or – 2° C).
•
: Water heating mode.
Maintains the water temperature at the heating temperature setting (+ or – 2° C).
•
: Water cooling mode
Maintains the water temperature at the cooling temperature setting (+ or – 2° C).
Water heating setting
• Turn the machine into heating mode (see « working modes »).
• Press
• Set the value with
Water cooling setting
• Turn the machine into cooling mode (see « working modes »).
• Press
• Set the value with
starts or stops the machine. (Attention! When the machine is being turned ON
is to choose the heat pump working mode.
, number « 1 » is shown followed by the heating setting value.
and
, number « 1 » is shown followed by the cooling setting value.
and
. It saves automatically after a few seconds.
. It saves automatically after a few seconds.
- 40 -