Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
REPLACING THE OVEN LAMP
To replace the rear lamp (if present):
1. Disconnect the oven from the power supply.
2. Unscrew the lamp cover (Fig. 6), replace the lamp (see note for lamp type) and screw the lamp cover back on (Fig. 7).
3. Reconnect the oven to the power supply.
Fig. 6
N.B.:
-
Only use 25-40W/230V type E-14, T300°C incandescent lamps.
-
Lamps are available from our After-sales Service.
IMPORTANT:
-
Do not use the oven until the lamp cover has been repositioned.
INSTRUCTIONS FOR OVEN USE
FOR ELECTRICAL CONNECTION, SEE THE PARAGRAPH ON INSTALLATION
1. Control panel
2. Upper heating element/grill
3. Cooling system (if present)
4. Dataplate (not to be removed)
5. Light
6. Baking ventilation system (if present)
7. Turnspit (if present)
8. Lower heating element (not visible)
9. Door
10. Position of shelves
11. Rear wall
N.B.:
-
At the end of cooking, after the oven has been switched off, the cooling fan may continue to run for a while.
Fig. 7
GB5
Publicité
Table des Matières
