Alphavox Technologies Signolux Mode D'emploi page 4

Function button:
When you feel the »Signolux-
pager« vibrating, you can stop
the vibration by pressing the
function button on the receiver.
The indicator LEDs will stay
illuminated, but will go out au-
tomatically after a total of 40
seconds.
Furthermore, you can press
the function button to call up
the most recent signal again
(the function works for up to 3
minutes after receiving the sig-
nal).The function button is also
used to program the receiver
(see section 3 „Programming
signals").
Belt clip:
You can use the belt clip to
attach the »Signolux-pager« to
your clothing.
On/off switch:
Use this switch to turn the pager
on and off.
Delete button:
This button serves to remove
transmitters assigned to an
event indicator symbol (see
section 4 „Deleting transmitters
from receiver memory").
English 4
Setting up the system
1. Inserting the battery
There is a battery compartment on
the underside of the »Signolux-
pager«. Open it by sliding the
cover of the battery compart-
ment away from the receiver
using both your thumbs.
Insert two 1.5 V AAA batteries
and close the receiver again.
2. Switching the unit on
Set the on/off switch to »on«. The
»Signolux-pager« is now ready
to operate. After the unit has
been switched on, the battery
status LED lights up for about a
second.
3. Programming signals and
assignment to the symbols
A transmitter (e.g. doorbell push-
button) can
to each event symbol. This
assignment can be adapted by
programming. Up to 6 transmit-
ters can be assigned to each
symbol. Please keep in mind
that a transmitter can only be
assigned if it is not yet known
in the memory of the »Signolux-
pager«.
be assigned