Mr Handsfree Blue Bird Mode D'emploi page 5

All manuals and user guides at all-guides.com
The Blue Bird Headset must be turned off before initiating pairing.
seconds until the blue (4) and red (5) indicators of the Headset are flashing alternatively.
now ready for pairing. (If you are wearing the Headset during the pairing process, you will hear 1 short tone
when the Headset is ready for pairing.)
pair with the Blue Bird Headset. (Refer to the manual of your mobile phone.)
PIN-code to complete pairing, enter 1234 and confirm it.
indicator (5) of the Headset will turn off and the blue indicator (4) will flash slowly.
Note:
1. If the Blue Bird Headset is not in pairing mode, your mobile phone won't find the Headset. Please set the
Headset into pairing mode before letting your mobile phone search for the Headset.
2. If no pairing is possible for a period of time (approx. two minutes), the Headset will automatically turn off,
and the previous pairing (if any) is revoked. You may need to start all over again.
3. Paired devices remain paired even when:
• One of the devices is not turned on.
• A service connection is interrupted or the service stopped.
• One or both devices are rebooted.
MAKING AND ANSWERING / ENDING CALLS
Once the Blue Bird Headset is successfully paired with your mobile phone, you can use it to make and
receive calls. The Blue Bird Headset can be used with voice dialing if your mobile phone supports this
feature.
MAKING CALLS
Using voice dialing:
Press the S1 button (3), wait for a beep and say the name of the person you want to call.
button (3) again to cancel voice dialing.
Using the phone keys to make a call:
Enter and dial the number on the mobile phone as you normally do.
sound will be transmitted to your Headset automatically.
Redial:
Press and hold the S2 button (2) for 3 seconds to redial the last number you called.
ANSWERING / ENDING CALLS
When the Blue Bird Headset is turned on and there is an incoming call, you will hear a musical tone and
the blue indicator (4) will change to a quick-flashing mode.
press and hold the S1 button (3) for 3 seconds to reject the call.
the S1 button (3) to increase the volume and pressing the S2 button (2) to decrease the volume.
call by pressing and holding the S2 button (2) for 3 seconds.
When the Headset is turned off, press and hold the S1 button (3) for 3 seconds to turn the Headset on.
Then press the S1 button (3) again to answer the call.
m_BlueBird_GB_.pmd
3
Press and hold the S1 button (3) for 6
Initiate the pairing process on your Bluetooth
When the pairing has been successful, the red
Press the S1 button (3) to answer the call or
Adjust the Headset volume by pressing
English
3
The Headset is
®
mobile phone to
You will be asked to enter the
Press the S1
Once the call has been set up, the
End the
28.09.2006, 16:24