Publicité
Les langues disponibles
Les langues disponibles
RECHARGING PROCEDURES
CHARGING THE JUMPSTART POWER SUPPLY
BATTERY
This unit has a built-in lead acid battery. Although the Jumpstart system arrives
partially-charged from the factory, it should be fully charged - at least 12 hours-
before initial use.
TO RECHARGE WITH RESIDENTIAL POWER AND THE
AC POWER ADAPTOR:
1. Be sure the master power switch (L, fig.1) on the control panel is off (the side
of the switch marked "O" is depressed).
2. Remove the AC power adaptor with its DC power plug (T, fig.2) from the rear
storage compartment.
3. Plug the AC adaptor into any 120 volt AC wall outlet and the other end into the
input charging jack (D, fig.1) of the Jumpstart System.
4. The charging indicator light (E, fig.1) will illuminate to indicate the Jumpstart
is being charged.
5. Full charging may take approximately 20 hours.
6. When the master power switch is turned on (the side of the switch marked "I" is
depressed), the battery charge-level indicator lights (G, fig.1) on the control
panel will illuminate:
•
Two green lights– full charge
•
One green light– good charge
•
Amber – weak: recharge
•
Red – dead: recharge
TO RECHARGE IN YOUR VEHICLE WITH THE DC POWER CORD:
1. Be sure the master power switch (L, fig 1) on the control panel is off (the side
of the switch marked "O" is depressed).
2. Be sure the vehicle is running.
3. Remove the 12 volt DC cigarette lighter adaptor, charging plug and cable
(U, fig.2) from the rear storage compartment.
4. Plug the 12 volt DC cigarette adaptor charging plug into your vehicle's cigarette
lighter socket.
. Insert the DC power plug at other end of the cable into the input charging jack
(D, fig 1) of the Jumpstart system.
6. The charging indicator light (E, fig 1) will illuminate to indicate the Jumpstart
is being charged. You can now recharge your Jumpstart for as long as your
vehicle is running.
7. Full charging may take approximately 11 hours.
8. When the master power switch is turned on (the side of the switch marked "I" is
depressed), the battery charge-level indicator lights (G, fig.1) on the control
panel will illuminate:
•
Two green lights– full charge
•
One green light– good charge
•
Amber – weak: recharge
•
Red – dead: recharge
NOTE:
= Do not drive while the Jumpstart is connected to- and charging from- the ciga-
rette lighter or power port of your vehicle.
= Some vehicles' cigarette lighters and 12 volt power ports do not operate un-
less the ignition switch is in the necessary position.
WARNING!
= Do not continuously charge the Jumpstart for more than 36 hours.
= Use only the power cords that were provided with the IJS2000 Jumpstart unit
when charging, otherwise damage to the unit may result.
NOTE: Keep battery power topped up, ready for emergencies. Unlike some re-
chargeable batteries, frequent charging will not harm and will in fact improve
the performance of the internal battery.
6
All manuals and user guides at all-guides.com
!
Publicité
