Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Operation
1.
See the Settings Table. Set the selector to the proper setting and connect the test leads to
the meter. Start with the highest measurement range.
Settings Table
To measure
set the selector
this value ...
to this symbol ...
Continuity*
Current (AC)
10 A Range
Current (AC)
Other Ranges
Current (DC)
10 A Range
Current (DC)
Other Ranges
Diode
Frequency
Resistance
Voltage (AC)
Voltage (DC)
Transistor Gain**
PNP or NPN
symbol on display indicate continuity. Threshold is approximately 80 Ω.
* Tone and
** Insert the legs of the transistor (emitter, base and collector) so they correspond to the
terminals (E, B and C).
2.
See Typical Measurements for specific measurement instructions.
3.
Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning circuit, replace the
battery and/or fuses.
• If the unit still does not function as expected, send the unit to Greenlee for repair.
4.
Take the reading from the circuit or component to be tested. If the resolution is not
satisfactory, remove the meter from the circuit and change to the next lower range.
this icon will
appear on
the display ...
Ω
A
(no icon)
µA, mA, or no icon
A
A
(no icon)
µA, mA, or no icon
A
(no icon)
Hz
KHz or MHz
Ω
Ω, KΩ, or MΩ
V
V or mV
V
V or mV
(no icon)
93-606
connect
and connect
the red
the black
lead to ...
lead to ...
VΩ
COM
A
COM
mA
COM
A
COM
mA
COM
VΩ
COM
VΩ
COM
VΩ
COM
VΩ
COM
VΩ
COM
N/A
N/A
9
Publicité
