Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE & CARE
12
12E
12D
12C
12 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (12A). Turn Valves (12B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (12A) by
separating the Aerator Shell (12C), Basket (12D), and Washer (12E). Once parts have
been cleaned, reassemble by reversing steps.
13
13B
13C
13 VALVE CARTRIDGE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet! With
Valves in "Closed" position, unscrew Fastener (13A) and remove Handle Hub (13B) from
Valve Stem (13C). Unscrew Retainer Nut (13D) by turning it counter-clockwise and lift
out Cartridge Assembly (13E) and inspect. Replace parts as necessary. Reassemble
parts by reversing steps.
12A
12B
13A
13D
13E
ENGLISH
CAUTION: Maintenance
DISASSEMBLY
1.
Replacement parts may be available at the store where you purchased
your faucet.
2.
When replacement parts are not available, please write or call Pfister
Consumer Service.
3.
Always turn off water and relieve pressure before working on your
faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp cloth
to clean and shine. Use of polish, detergents, abrasive cleaners,
organic solvents or acid may cause damage. Use of other than
a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance
are not acceptable for public areas or Commercial use. Installation
of Said Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pfisterfaucets.com
• Installation Support
• Care and Warranty Information
4
Publicité
