Publicité
Two people are needed to install the display on the stand. Insert the
four Keyhole Shoulder Washers through the four Keyhole slots and
then use four "H" Button Head Screws to permanently attach the Display
Two people are needed to install the display on the stand. Insert the four "D" screws through the four
Beam and Display unit to the stand. Replace Upper & Lower Rear Cover.
"Keyhole Slots" and while still supporting the display, attach four "C" screws in the locations shown below.
Tighten all six screws to complete the display installation.
XL Fixed Height, Mobile Stand Designed for 85" Surface Hub 2S
www.salamandercommercial.com
H x 4
501-692/MS [10.22]
page 8 of 21
Publicité
