Bleeding Procedure
1.1
Drain old fluid from brake master cylinder reservoir and top up
with new fluid.
1.2
Begin fluid bleed procedure from wheel furthest from the
master cylinder.
1.3
Connect rubber bleeder fitting to caliper bleed nipple and open
nipple 1/4" turn only.
1.4
Operate brake bleeder
and allow fluid to flow
until clear fluid is
seen in tube.
1.5
Close off bleed nipple.
1.6
Top off fluid level.
1.7
Repeat bleed procedure at
each wheel.
At the completion of bleeding,
check for firm brake pedal.
www.matcotools.com
BBVQF
2007128-33