Matco Tools DT4A Mode D'emploi

Matco Tools DT4A Mode D'emploi

3.5 gonfleur de pneu digital avec tuyau

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

WARNING
Study, understand and follow all instructions provided with this product.
Read these instructions carefully before installing, operating, servicing
or repairing this tool. Keep these instructions in a safe accessible place.
INTENDED USE OF THE TOOL
For inflating, deflating and measuring tire pressure via the tire's valve stem.
Do not use this tool outside of the designed intent. Never modify the tool for
any other purpose or use.
WARNING
• Normal use of this product is likely to expose the user to
dust and/or microscopic particles containing chemicals
known to the State of California to cause cancer, birth
defects or other reproductive harm. Always wear
appropriate safety equipment and clothing when using this
product. Study, understand and follow all instructions
provided with this product. Failure to read and follow all
warnings and operating instructions may result in damages
and serious injury or death.
• Always wear ANSI approved goggles when using this
product. (Users and Bystanders).
• Never use this tool for any application other than for
which it was designed.
• Only use accessories designed for this tool.
• Never alter or modify this tool in any way.
• Improper operation and/or maintenance of the tool,
modification of the tool, or use of the tool with accessories
not designed for it could result in serious injury or death.
• Always select the correct accessories of the correct size
and design for the job that you are attempting to perform.
• Always work in a clean, safe, well-lit, organized and
adequately equipped area.
3.5" DIGITAL TIRE INFLATOR WITH HOSE
MODEL:
DT4A
MADE IN CHINA
Page 1
Product Type:
3.5" DIGITAL TIRE INFLATOR WITH HOSE
1 YEAR LIMITED WARRANTY
The manufacturer warrants this product to the original user against defective material
or workmanship for a period of 1 year from the date of purchase.
The manufacturer reserves the right to determine whether the part or parts failed
because of defective material, workmanship or other causes. Failures caused by
accident, alteration, or misuse are not covered by this warranty.
The manufacturer, at its discretion, will repair or replace product covered under this
warranty free of charge. Repairs or replacements of products covered under this
warranty are warranted for the remainder of the original warranty period.
The manufacturer or its authorized service representatives must perform all warranty
repairs. Any repair to the product by unauthorized service representatives voids this
warranty. The rights under this warranty are limited to the original user and may not be
transferred to subsequent owners.
The warranty is in lieu of all other warranties, expressed or implied, including
warranties of merchantability and fitness for a particular purpose. Some states do not
allow the exclusion or limitations of incidental or consequential damages, so the above
limitations may not apply to you.
BEFORE USE
When unpacking, check the parts diagram and part number
listing on page 4 to make sure all parts are included. If any
parts are missing or damaged, please call your distributor.
PRODUCT INFORMATION:
• Easy Change Chuck System
• 1 Button Operation
• Auto shut-off for increased battery life
• Displays KGF, BAR, PSI, KPA measurement
• Large face LCD digital read-out
• Unit covered with rubber sleeve for extra comfort and durability
• On Power Button, auto shut off in 90 seconds if not in use
• LCD Back Light
• Allows accurate reading of tire pressure, assisting with TPMS
(Tire Pressure Monitoring Systems)
• Two position lever. 1st position deflates, 2nd position inflates
• Works on a nitrogen system
• With 21" Hose
FUNCTION KEY:
ON/UNIT/LIGHT: Press once to turn on. Press again to turn on backlight.
When the unit is on, press for 3 seconds to switch to desired unit. If display
is unreadable or will not change, press and hold the button for 8 seconds to
restart.
TWIST/THREAD CHUCK ONTO VALVE STEM TO FULLY SEAL
SPECIFICATIONS:
Measuring Range:
3-175 psi
Units:
PSI / BAR / KPA / KGF
Resolution:
0.1 psi
Accuracy:
Compliance with European Community Council
Directive 86/217/EEC
0-58 psi +/- 1.2 psi
59-174 psi +/- 2.0 psi
Working Temperature:
32°F-104°F (=0°C-40°C)
Power:
Lithium batteries
Battery Lifetime:
140hr
DO NOT DISCARD – GIVE TO USER
1503038-14MA

Publicité

Table des Matières
loading

Sommaire des Matières pour Matco Tools DT4A

  • Page 1 MODEL: Product Type: DT4A 3.5" DIGITAL TIRE INFLATOR WITH HOSE WARNING Study, understand and follow all instructions provided with this product. Read these instructions carefully before installing, operating, servicing or repairing this tool. Keep these instructions in a safe accessible place.
  • Page 2: Important

    MODEL: Product Type: DT4A 3.5" DIGITAL TIRE INFLATOR WITH HOSE OPERATING INSTRUCTION 1. Remove tire valve cap. 2. With clip-on air chuck lever depressed, firmly press chuck onto tire valve stem and release lever, and ensure that no air leaks.
  • Page 3 MODELO: Tipo de Producto: DT4A 3.5 INFLADOR DE NEUMÁTICOS DIGITAL CON MANGUERA ADVERTENCIA Estudie, entienda y siga todas las instrucciones que se proveen con este producto. Lea las instrucciones detenidamente antes de instalar, operar, dar servicio o reparar esta herramienta. Guarde estas instrucciones en un lugar seguro y accesible.
  • Page 4 MODELO: Tipo de Producto: DT4A 3.5 INFLADOR DE NEUMÁTICOS DIGITAL CON MANGUERA INSTRUCCIONES DE OPERACION 1. Quitar la tapa de la válvula del neumático. 2. Manteniendo la palanca (que se encuentra al final de la manguera) oprimida, firmemente presione el mandril contra la valvula del neumatico y suelte la palanca asegurandose de que no haya escape de aire.
  • Page 5: Gonfleur De Pneu Digital Avec Tuyau

    MODÈLE: Type de Produit: DT4A 3.5 GONFLEUR DE PNEU DIGITAL AVEC TUYAU AVERTISSEMENT Etudier, comprendre et suivre toutes les instructions fournies avec ce produit. Lire ces instructions attentivement avant d’installer, d’utiliser, d’entretenir et de réparer cet outil. Conserver ces instructions dans un endroit sécuritaire et accessible.
  • Page 6: Type De Produit

    MODÈLE: Type de Produit: DT4A 3.5 GONFLEUR DE PNEU DIGITAL AVEC TUYAU DIRECTIVES D'UTILISATION 1. Ôter le capuchon de la valve du pneu. 2. Avec le levier de mandrin pneumatique équipé d'un clip abaissé, appuyer fermement le mandrin sur la tige de la valve du pneu et relâcher le levier, tout en surveillant toute fuite d'air.
  • Page 7 MODEL: Product Type: DT4A 3.5" DIGITAL TIRE INFLATOR WITH HOSE WARNING Caution: To help prevent personal injury • Normal use of this product is likely to expose the user to dust and/or microscopic particles containing chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Always wear appropriate safety equipment and clothing when using this product.
  • Page 8: Parts Breakdown

    MODEL: Product Type: DT4A 3.5" DIGITAL TIRE INFLATOR WITH HOSE PARTS BREAKDOWN 11B02 12B02 11B01 12B01 12B03 Parts List Index No. Part No. Description Index No. Part No. Description DT4-01* Front Cover DT4-12 Valve Base Assembly DT4-02* PCB Board Assembly...

Table des Matières