Parkside PDSB 10 A1 Traduction Des Instructions D'origine page 7

Before use
Dust/chip extraction
CAUTION!
► Please refer to the section entitled "Safety
instructions" .
► Only use the appliance in the vacuum func-
tion when the dust bag is fitted . Otherwise,
particles can be accelerated towards the
user .
CAUTION!
► First fit the angle piece
tion connection
to vacuum sharp-edged or metal swarf . Oth-
erwise, these could damage the dust bag
Dust extraction unit with dust bag:
♦ First, push the hose clip
the dust bag .
♦ Push the opening of the dust bag
dust extraction connection
♦ Push the hose clip
connection .
♦ Tighten the hose clip
clockwise .
NOTE
► Empty the dust bag
regularly in order to guarantee optimal dust
extraction . To do this, open the zip on the
underside of the dust bag
■ 4 │ GB │ IE │ NI
All manuals and user guides at all-guides.com
to the dust extrac-
if, for example, you want
over the opening on
onto the
.
over the dust extraction
by turning its wing nut
in good time and
.
Using attachments
You can attach a range of blow-out and vacuum
attachments to the appliance in order to reach
inaccessible locations .
♦ Push the flexible hose
After this, push the required nozzle
flexible hose
the extension tube
its own .
Use
Connecting the compressed air supply
NOTE
► The appliance may only be operated using
.
cleaned, condensate-free compressed air,
and the maximum operating pressure of 10
bar must not be exceeded on the appliance .
► To ensure that you can regulate the air pres-
sure, the compressed air source should be
equipped with a (filter) pressure reducer .
♦ Connect the connector nipple
pressed air supply using a quick coupling .
Switching on and off
Switching the compressed air appliance on:
♦ press the operating lever
Switching the compressed air appliance off:
♦ Release the operating lever
♦ Disconnect the appliance from the compressed
air source after you finish work .
NOTE
► First detach the hose from the compressed air
source (compressor) before disconnecting the
supply hose from the appliance . This prevents
the supply hose from thrashing about .
over the opening
. Alternatively, you can also fit
over the opening
to the com-
completely down .
.
PDSB 10 A1
.
onto the
on