Axis P7216 Instructions D'installation page 14

AXIS P7216 Video Encoder
Install the Hardware
Mount the video encoder
The AXIS P7216 is supplied with a mounting kit containing brackets. The unit can be mounted in
a rack or on a wall.
After removing the existing 4 screws, attach the mounting brackets to the video encoder at an
angle suitable for installation in a standard 1U 19" rack, or on the wall.
Mounting on a wall
1. Position the video encoder against the wall with the brackets attached, and mark the
four mounting holes for each bracket.
2. Drill the four mounting holes.
3. Attach the video encoder to the wall using appropriate screws.
Connect the cables
1. Connect the video encoder to the network using a network cable RJ45 (NET) and/or a
SFP module and optic fibre or copper networking cable.
2. Optionally connect the external input/output devices.
3. Optionally connect active speakers and/or external microphones.
4. Connect the cameras to the video inputs.
5. Connect the supplied indoor power adapter.
6. Check that the indicator LEDs indicate the correct conditions. See LED Indicators on
page 8
NO NO NO TICE TICE TICE
Make sure the unit is properly grounded by using the grounding screw.
If the unit will be used with cameras or accessories located outdoors then its ground screw
should be connected to a local grounding point.
Note
In order to use the built-in network redundancy functionality, both the RJ45 (NET) and the
SFP module must be connected. See Network Redundancy on page 15
Auxiliary Connector
The video encoder is equipped with an additional RJ45 network connector. The purpose with
this connector is to simplify maintenance work on the video encoder that requires connection
to a computer.
All manuals and user guides at all-guides.com
14