Télécharger Imprimer la page

steelplay DUAL CHARGING STANG Manuel D'utilisation page 6

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
5. USE
DISPOSAL OF WASTE ELECTRICAL AND ELECTRIC EQUIPEMENT
This device is designed for domestic indoor use and should not be used otherwise. Follow the safety instructions in the manual
Observe the safety rules when disposing of waste electrical and electronic equipment (WEEE).
6. CABLES -
WARNING : Cable and cord.
Place all cables and cords so that nobody (or pet) can be caught in the feet or shot by mistake by moving in the room. Keep cables
and cords out of reach of children and pets. Do not let children play with cables and cords. If you do not plan to use this product
for a long time, turn it off by disconnecting the power plug. During thunderstorms, we recommend disconnecting the product so
that it is not damaged by possible electrical or electromagnetic surges. For this reason, the outlet should be easily accessible,
so as to disconnect when needed. Unplug the device immediately if you notice it exudes a burnt or smoke. Do not under any
circumstances open the product yourself, you might receive an electric shock. Do not touch the power plug with wet hands. Also,
if the plug is wet or covered with dust, dry or completely wipe the power cord. Excessive moisture can cause electric shock. Be
sure to connect the power cable to a grounded outlet. (Does not apply to devices that do not require grounding.) If it does not,
you may be electrocuted or injured. Attach the power cord. If the power cable is not attached properly, a fire may occur. Make
sure the power cord is not in contact with hot objects like a heater. Failure to do so may cause fire or electric shock. Do not place
heavy objects or the product itself, on the power cord. Do not plug too many devices on one wall strip. Do not insert a conductor
wire as a metal rod in one end of the power cable if the other end is connected to the wall input terminal. Also, do not touch the
power cord right after the connection.
INTRODUCTION
The Steelplay® Dual Charging Stand allows you to securely store and charge up two PS4
Content
1 charging stand, 1 USB cable, 1 manual sheet
Fonctionnement
Place the product on a flat surface close to all the components and the input devices you want to use. Attach one or two PS4TM
controllers to the charging station. Align the charging connector on the charging station with the extension port on the controller,
and press down on the controller until it clicks. Connect the cable between the USB port (located at the back of the station) and the
PC or the PS4TM console. Full charge of 1 joystick can be completed between 2 hours, 4 hours for 2 controllers simultaneously.
Colored LED lights indicate charge status (charging : red or charged : green). 2 additional ports (on the side of the station) can be
used to charge 2 extra controllers with an AC adapter (not included).
Orientating stand
Orientating stand
LED indicator
Charge pin
LED indicator
Charge pin
controllers simultaneously
TM
USB output jack
USB micro jack
LED indicator
USB outout jack

Publicité

loading