steelplay DUAL CHARGING STANG Manuel D'utilisation page 5

EN - USER MANUAL
Thanks for choosing the Steelplay® Dual Charging Stand. To ensure the safe use of the product, please read carefully the
instruction manual before using it and keep the manual for any future reference.
WARNING - FOR YOUR SAFETY WHEN USING THIS PRODUCT, WE RECOMMEND THAT YOU READ THIS MANUAL AND
RETAIN THESE DOCUMENTS FOR FUTURE REFERENCE CAREFULLY.
SAFETY INSTRUCTIONS
1. SAFETY OF CHILDREN AND VULNERABLE PEOPLE
AVERTISSEMENT :Risque de suffocation
Make sure to never leave this product within the reach of young children. Do not let children play with the device. Do not leave
packaging within the reach of children. Children should not clean or attempt any maintenance on the device unattended.
2. GENERAL SECURITY
WARNING: Risk of injury, electric shock, fire, burns or damage to the device
WARNING: Do not attempt repairs
WARNING: Do not allow your accessory to become wet
Do not use the product with wet hands and avoid any kind of moisture. Do not move the product when it is powered. Do not drop,
do not disassemble, do not open, do not crash, do not bend, do not deform the product or any of its parts, this could seriously
damage them. Do not use water to clean the product or any other cleaning agent. Do not use abrasive cleaners, scouring pads,
solvents or metal objects. To clean the product, use an anti-static cloth. To avoid electric shock, do not disassemble the product
yourself. All repairs must be performed by qualified personnel. Prevent any liquid from entering the product. Do not insert any ob-
ject other than those permitted in the product as they may touch dangerous voltage points or cause a short circuit resulting in a fire
or electric shock. Do not place heavy objects on the product. Avoid excessive shock or vibration of the unit. This unit is intended for
indoor use only. The unit must not be exposed to water dripping or splashing. Do not place objects filled with liquids such as vases
on the device. Do not change the specifications of this device. If the power cable is damaged, it must be replaced by the manufac-
turer, its service agent or a qualified technician to avoid a hazard. Before any maintenance, switch off and unplug the AC power
supply. Do not spray water or steam to clean the unit. Be careful not to hurt your hands or fingers on the sharp corners. Check
that the mains voltage corresponds to the voltage indicated on the label on the back of the product or in the user manual. The
lack of light does not mean that the product is completely disconnected from the power supply. To disconnect the device, remove
the cable. The humidity of the room where the product is installed must not exceed 90%. The transfer of the product from a cold
to a warm place may cause condensation on some components. Let the condensation evaporate before turning on the device.
3. INSTALLATION
Do not install and do not connect a damaged device. Carefully follow the installation instructions provided with the device. Do not
install or do not use it in a place where the temperature is below 15 ° C or in a place exposed to the elements. Do not place the
product in direct sunlight or near a source of heat. Install the product in a dry place and protected from dust. Do not place in areas
subject to splashing water. Do not place the device flame sources such as lighted candles. Before installing the device, make sure
the surface will bear his weight. Do not place this product on an unstable surface. Do not install the product on shelves or on a
sloping surface. Also avoid locations subject to vibration or not to support the product properly. Otherwise, the product may fall,
which can lead to injury or damage the product.
4. ELECTRICAL CONNECTION
WARNING : Cable and cord. Place all cables and cords so that nobody (or pet) can be caught in the feet or shot by mistake by
moving in the room. Keep cables and cords out of reach of children and pets. Do not let children play with cables and cords. If you
do not plan to use this product for a long time, turn it off by disconnecting the power plug. During thunderstorms, we recommend
disconnecting the product so that it is not damaged by possible electrical or electromagnetic surges. For this reason, the outlet
should be easily accessible, so as to disconnect when needed. Unplug the device immediately if you notice it exudes a burnt or
smoke. Do not under any circumstances open the product yourself, you might receive an electric shock. Do not touch the power
plug with wet hands. Also, if the plug is wet or covered with dust, dry or completely wipe the power cord. Excessive moisture can
cause electric shock. Be sure to connect the power cable to a grounded outlet. (Does not apply to devices that do not require
grounding.) If it does not, you may be electrocuted or injured. Attach the power cord. If the power cable is not attached properly, a
fire may occur. Make sure the power cord is not in contact with hot objects like a heater. Failure to do so may cause fire or electric
shock. Do not place heavy objects or the product itself, on the power cord. Do not plug too many devices on one wall strip. Do not
insert a conductor wire as a metal rod in one end of the power cable if the other end is connected to the wall input terminal. Also,
do not touch the power cord right after the connection.