JessEm TA FENCE 04500 Manuel Du Propriétaire page 8

STEP 4: Now that your fence is fastened in to the fence tracks, you will need to align the fence to
the bit opening and adjust your scales accordingly.
a)
Ensure your router is mounted in the table top with a router bit in your router.
b)
Loosen the Clamping Knobs (Part # 45 ), and slide your fence so it is centered around the router bit.
c)
Now check that the fence is parallel to the front edge of the table.
d)
Tighten the Fence Clamping Knobs.
Figure 10
e)
Ensure the right and left hand track scale (Part #14) are on the proper sides, See Figure 11.
With the 1/8" hex key provided, loosen the set screws on the front of the left and right hand
f)
scales. See Figure 11.
g)
Slide the scale to line the "0" on the scale to the front edge of the fence. See Figure 12.
Ensure scales are
on correct side
Figure 11
h)
Tighten the set screw. Repeat this for the other scale on the opposite side of the fence. The
TA fence should be centered on your router table.
All manuals and user guides at all-guides.com
CENTERING YOUR TA FENCE ON THE TABLE:
Figure 12
8