Hilti TE 30 Mode D'emploi Original page 22

All manuals and user guides at all-guides.com
5.2.1 Function selector switch
▶ Set the function selector switch to the desired working position.
◁ Do not operate the function selector switch while the motor is running. Risk of damage!
5.2.2 Drilling without hammering
▶ Set the function selector switch to this symbol:
5.2.3 Drilling with hammering action (hammer drilling)
▶ Set the function selector switch to this symbol:
5.2.4 Positioning the chisel (only TE 30-AVR)
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function
selector switch until it engages in the "Chiseling" position.
▶ Set the function selector switch to this symbol:
◁ The chisel can be adjusted to 12 different positions (in 30° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
5.2.5 Chiseling (only TE 30-AVR)
▶ Set the function selector switch to this symbol:
5.2.6 Forward / reverse
▶ Set the forward/reverse switch to the desired direction of rotation.
◁ Do not operate the function selector switch while the motor is running. Risk of damage!
6 Care and maintenance
WARNING
Danger of electric shock! Carrying out care and maintenance while the supply cord is connected to
the power outlet presents a risk of serious injuries including burns.
▶ Always unplug the supply cord before carrying out all care and maintenance tasks.
Care
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
they can attack the plastic parts.
Maintenance
WARNING
Danger of electric shock! Improper repairs to electrical components may lead to serious injuries
including burns.
▶ Repairs to the electrical section of the tool or appliance may be carried out only by trained electrical
specialists.
• At regular intervals, check all visible parts and the controls for signs of damage and make sure that they
all function correctly.
• Do not operate the power tool if signs of damage are found or if parts malfunction. Have damage repaired
immediately by Hilti Service.
• After cleaning and maintenance, refit all guards or protective devices and check that they function
correctly.
16 English
Printed: 14.05.2018 | Doc-Nr: PUB / 5324616 / 000 / 01
6
6
6
6
7
.
6
.
.
.