Blackstone 2142 Mode D'emploi page 5

Model: 2142
ASSeMBlY INSTRUCTIoNS
Find a large, clean area to assemble your appliance�
Remove all packing material before assembling�
Sharp edges. Wear gloves while assembling.
Remove the griddle body from the packaging and set it
STEP 01
upside down�
Screw the four (4) griddle feet into the bottom of the griddle body�
Set the griddle on its feet�
STEP 03
ensure that the ignition needle is positioned 3-7mm away from the
burner tube, positioned above the burner hole�
BLACKSTONEPRODUCTS.COM/SUPPORT
CAUTIoN
NOT INCLUDED:
lPG cylinder
Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg) Size: 18 x 12 in (45 x 30 cm), 20 lb (9 kg)
lPG cylinder must include collar to lPG cylinder must include collar to
protect lPG cylinder valve. protect lPG cylinder valve.
NOT INCLUDED:
17" griddle base
3-7mm 3-7mm
ASSEMBLY GUIDE
Clean the inside of
STEP 03
the burner:
• Run a narrow bottle brush
through each burner tube
several times� (do NoT use
wire brushes)
• Run a stiff wire bent into a small
hook through each burner tube
several times�
• Use compressed air to blow
through the burner tube and
out the burner ports� Check that
air blows through each hole�
(Wear eye protection)
NOT INCLUDED:
lPG cylinder
Brush entire
STEP 04
Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g) Size: 4 x 8 in (10 x 20 cm), 1 lb (453 g)
outer surface of burner to
remove grime�
Clean any blocked ports
STEP 05
with stiff wire such as an open
ensure that the fuel nozzle is housed within the
STEP 02
paper clip�
burner opening�
Carefully replace burners
STEP 06
and reattach�
The gas rail fuel nozzle
must be reengaged within the
burner opening�
NOT INCLUDED:
22" griddle base
Make sure the front pins are fully place the griddle top on the main body by aligning the 4 pins
STEP 04
seated in the holes, then push to the holes of the body�
the griddle top forward to lock
the griddle in place�
Make sure the front pins are fully
seated in the holes, then push
the griddle top back to lock the
griddle in place�
| OWNER'S MANUAL
NOT INCLUDED:
AA battery
Fuel nozzle Fuel nozzle
Burner opening Burner opening
ELECTRIC REQUIREMENTS:
120V 60Hz
NOT
AAA
Mak
seat
the
the
Mak
seat
the
grid
05