LD Systems DIO 04 Manuel D'utilisation page 13

DANTE® CONTROLLER
A Dante® network is set up using the freely available DANTE® CONTROLLER software. Download
the software from the manufacturer's website www.audinate.com and install it on a computer.
Connect the computer's Ethernet interface to a network interface using a network cable (Cat. 5e
or better) and run the Dante® Controller software. The software has an automatic device detection
function. Signal routing is done by mouse click and the unit and channel designations can be
individually edited by the user. IP address, MAC address and other information about the devices
in the Dante® network can be displayed in the software.
Once the configuration of the devices on the Dante® network is complete, the Dante® Controller
software can be closed and the computer disconnected from the network. The settings in the
units in the network are retained.
When the DIO 04 is disconnected from the Dante® network, the unit's audio outputs are muted
and the power icon on the front panel starts flashing.
13