1. Before using the fan, make sure that it is on a flat and stable surface.
Damage may occur if the fan is placed on an incline or decline.
2. Set all the switches to the "OFF" position, and then insert the plug
directly into a standard AC socket-outlet. Be sure that the plug fits
tightly into the socket-outlet.
3. Press "ON/SPEED" on the remote or on control panel to start the fan.
Press "ON/SPEED" button again to select the fan speed level. The fan
have three speed level.
means low speed level,
means middle
speed level,
means high speed level.
Press "MODE" button to select the fan mode, the fan have three mode.
means "NORMAL" wind.
means "NATURAL" wind.
means "SLEEP" wind.
Press "TIMER" button to set timer from 0.5hour to 7.5 hour. Every time
press this button will add 0.5H timer.
To cancel the set timer, press the
"
" button again until all the timer indicate turn off.
TIMER
To stop the fan, just press the button "OFF" on remote or " " on control
panel.
4. If you want to increase the blast area in your room, press "SWING"
button on remote or press "OSC" on control panel,
the LED screen will
, and the fan will oscillate and blast your
indicate
room in large scope. To stop oscillating, just press it again. Moving the
fan head either up or down will change the direction of the wind.
6