Create TOAST STUDIO Mode D'emploi page 7

• Do not touch electrical appliances if they have fallen in the water. Imme-
diately pull the plug out of the socket. Stop using the appliance.
• Make sure that electrical appliances, cords and plugs do not come into
contact with heat sources, such as a hot hob or open fire.
• Never let cords hang over the edge of the sink, a worktop or a table.
• Always remove plug from the socket when you are not using the electri-
cal appliance.
• Remove the plug from the socket by pulling the plug itself and not the cord.
• Regularly check if the cord of the electrical appliance is not damaged.
Do not use the electrical appliance if the cord shows signs of damage.
If the cord is damaged, it should be replaced by the manufacturer, a te-
chnical service provider or a person with an equivalent qualification, to
avoid any danger.
• The appliance may not be switched on with the aid of an external time
switch, or by a separate system with remote control.
• Be careful when using the appliance outdoors.
• Never use the appliance in damp or wet locations.
• Thoroughly clean the appliance after use (see Cleaning and Maintenance).
1. Slots for toasting bread
2. Lift lever
3. Defrost button
4. Cancel button
5. Reheat button
6. Roast controller
7. Crumb tray
B E FOR E U SE
Operate the toaster a couple of times, without bread, at the maximum setting. This will
remove the last traces from the manufacturing process. A little smoke and odour may be
emitted by the toaster when it is used for the first time.
PRE PAR ATI ON
1. Put the appliance on a stable and flat surface.
2. Put the plug into the wall socket.
PARTS LIST
1
2
3
4
5
6
7
OPERATING INSTRUCTIONS
E NGLI SH
7