Publicité
EN
Preparing the Spring Cradle Motor
Once the preparation of the motor is completed,
use the pre-installed Snap Hook to attach it to the
desired suspension device (Frame, Door Clamp or
Ceiling Hook).
Attaching the Pull Rope
When the motor hangs safely, the
Pull Rope can be installed:
Make sure to run it in parallel to the springs
and use the lower knot to connect it to the
S-Hook. If your baby is still very small attach
the S-Hook to the upper knot instead. Short-
ened like this, the Pull Rope will ensure optimal
motor performance at little weight.
31
Publicité
