Akasa Integral Fusion Mode D'emploi page 3

fusion
Package contents
• INTEGRAL FUSION quad interface enclosure
• A-male to B-male USB2.0 cable (.5M)
• -touch backup software
• Footstand (Mounting )
• DC 2V power adapter
• User's Manual
• Installation kit for installing hard drive
Getting started
To install your new Integral Fusion enclosure you will
need:
• Hard Disk Drive (HDD) (not included)
• Philips-head screw driver (not included)
• Mounting screws (included)
• USB2.0 Data Cable (included)
• DC 2V power adapter
Hard disk installation
1
Remove the two rubber cushion inserts on the sides of the
enclosure.
2
Undo with cross head screw driver the four screws (2 upper on
each side)
2
All manuals and user guides at all-guides.com
3
4
5
6
Ensure that the Drive select feature on the drive is set to single/
master and connect up the IDE and Power connectors to the
drive.
Place the drive into the enclosure and secure it with the four
screws (2 on each side).
Locate the top cover back over the enclosure and fit the four
screws (2 upper on each side)
Refit the two rubber cushion inserts on the sides of the
enclosure