LiteHawk NEON AUTO Manuel D'instructions page 7

4/ Charge time can take up to 60 minute (less if charging for the first time). Once charged
the LED light on the USB will turn back on to RED.
For more tips visit us at www.litehawk.ca
Tip: If storing for more than 24 hours it is best to store with a fully charged battery. Failure
to do so can damage the battery pack and shorten its useful life.
- Always remove the battery from the toy for charging.
- Unplug the battery from the toy if storing for more than 24 hours.
During charging:
- It is normal for the battery to get warm during the charging process. Do not charge the
battery on a surface that is flammable or can be damaged by heat.
- Do not leave the battery and charger unattended while charging.
- After charging, unplug charger from model.
- Do not store the model plugged into the charger.
How To Sync
1/ Make sure the model is turned Off and locate a flat level surface.
2/ Plug the battery into the NEON AUTO and turn it on. Place the NEON AUTO on the flat
surface, you must do this within 5 seconds of turning the power switch ON. You will see
flashing lights on the NEON AUTO start to blink.
3/ Turn on the power for the controller. You will see a flashing red LED light and audible
beep indicating the power is on.
4/ Move the left control stick (this is also the throttle stick) all the way up, then all the
way down. In a few seconds the blinking LED on the NEON AUTO and the blinking LED on
the controller will both be solid. The model is now bound.
The NEON AUTO MUST be on a flat surface in order to digitally self level itself, otherwise
the model will not sync to the controller.
Your LiteHawk Drone is equipped with a barometric sensor which allows for
Altitude hold capability. The Drone will maintain your desired height while
flying.
ALTITUDE HOLD: You will notice the left stick is spring
loaded. To gain or increase altitude (height) push the stick
up. To lower altitude (height) push down. Once you get to
a desired altitude release the stick and the drone will stay
at that height.
The left control stick (throttle) is now spring loaded and
rests in the center position. If you want to climb just push
up on the throttle stick and release when you reach your
desired height. To lower the drone's height just push
down on the throttle stick.
AUTO TAKE OFF: Press the Auto Take Off/Land button to
start the motors on your drone. Now push up GENTLY on
the Throttle Stick, release the Throttle Stick at your desired
altitude.
AUTO LAND LAND: Press the Auto Take Off/Land button
to slow the motors on your drone - the drone will land
itself.
www.litehawk.ca
R