Sanyo VMC-L2617 Manuel D'instructions page 7

All manuals and user guides at all-guides.com
L8MAP_MAQ_US_XE_JP(GB_FE_ES_DE_CS_JP).book 6 ページ ２００９年７月７日 火曜日 午後４時５７分
Instructions for Use
Power On/Off
1
Switch the POWER button on.
• There will be a few seconds delay before the display appears.
• If no signal is being received in VGA mode, the power indicator will flash.
2
When viewing is finished, press the POWER button.
System ID
The System ID can be set for each monitor.
Ensure that the System ID matches the remote controller ID (Remote ID).
(Factory default) System ID/Remote ID : 1
1
Setting the unit System ID.
Press MENU button on the unit; use the cursor button to select the "System ID"
setting from the Setup menu, and then select an ID No. Close the menu screen.
2
Setting the Remote ID
While holding down the SYSTEM ID button, set the same number as the System
ID number by pressing the corresponding Number button [0-9].
• Press the ID RESET button to return the remote controller ID to the factory
default "1".
• Press the SYSTEM ID button to confirm the current System ID and Remote ID.
Basic Operations on the Menu-Screen
To display / exit the main menu
Main Menu
Picture
Mode
Contrast
Brightness
Sharpness
Color
Tint
Color Tone
Backlight
More
Move
To select the menu
Picture
Mode
Picture
Contrast
Brightness
Sharpness
Sound
Color
Tint
Color Tone
Setup
Backlight
More
Input
Move
■ How to Configure Setting
Using Adjustment Bar
Note:
The OSD display will be disapear after
2 minutes if there is no button input.
: Dynamic
100
45
50
55
G 50 R 50
: Normal
: 10
Button Operation Guide
Enter Return
To decide the menu
: Dynamic
100
45
50
55
G 50 R 50
: Normal
10
:
Enter Return
ENTER
Contrast
Adjust
Move
POWER
1
2
POWER
A
To return to the previous
menu-screen
Picture
Mode : Dynamic
Contrast 100
Brightness 45
Sharpness 50
Color 55
Tint G 50 R 50
Color Tone : Normal
Backlight 10
:
More
Move Enter Return
ENTER ENTER
100
Button Operation Guide
Return
1 2 3
1 2 3
4 5 6
7 8 9
ID RESET SYSTEM ID
0
B
C
ENTER
B
English 6