All manuals and user guides at all-guides.com
1. Low battery (Red 1)
2. Fully charged (Blue 1)
3. Low battery and robot in Stop/Pause mode
(Red 1 and blinking red 3)
4. Fully charged and robot in Stop/Pause mode (Blue 1 and blinking red 3)
4. ADAPTATEUR DE COURANT/RALLONGE CC
5. Low battery and cleaning (Red 1 and blinking blue 2)
6. Fully charged and cleaning (Blue 1 and blinking blue 2)
Cleaning tips
• Step I: Use clean and dry cleaning cloths to clean the dust and dirt on the window.
• Step II: Change the cleaning cloths when dirty. Spray a little bit of detergent (1~2 spray) on
the lower wheel and keep the upper wheel dry. Do not wet the cloth too much (if it gets
too wet, the machine cannot move properly). Then, clean the window again.
Operation
• Step I: Connect the robot to the mains suppy and tie the safety rope. Make sure the battery is
fully charged.
• Step II: Place the microfiber cloth in the cleaning wheels.
• Step III: Turn on the robot and place it on the window.
• Step IV: Choose the cleaning mode with the remote control.
• Step V: When the robot stops cleaning, grab it by the handle, turn off the switch, and remove it
from the window.
The vacuum cleaner robot has been equipped with 3 indicator lights with different functions:
· The first light, to the left, signals the state of the battery. When the battery is low, incomplete, or charging,
the light will turn red. When the robot is fully charged, the light will turn blue.
· The second light is in the centre and signals when the robot starts cleaning. This light turns on once the
robot is already attached to the window and starts a cleaning mode. When the robot is cleaning, the light
will turn blue and blink.
· The third right, to the right, signals when the robot is in Stop/Pause mode. This light turns on when the ro-
bot is attached to the window without cleaning, when the robot is in Stop/Pause mode, or when the robot
finishes the cleaning mode and stops. The light will turn red and blink.
4. POWER ADAPTER/DC
9. Power adapter
10. DC extension cable
11. DC plug
12. L-shape connector
13. Plug into DC power jack