Eco-De ABSOLUT ROBOT Mode D'emploi page 21

All manuals and user guides at all-guides.com
How to put the device on the window
- Turn on the power switch and make sure the fan is running.
- Put the device on the window, 10cm away from the frame.
- Check if the device sticks to the glass before releasing it.
How to take the device from the window
- Press Stop in the remote control.
- While the device is running, please hold the safety rope with one hand and take the device
from the window with the other hand.
- Turn off the power switch in a safe area.
THE USE OF THE SAFETY CORD IS OBLIGATORY.
Safety rope
- Check if the safety rope is broken or the knot is loose before use.
- Fasten the safety rope and tie it to an indoor fixture before use. UPS (Uninterrupted Power System)
function
- must always be connected to the mains supply.
- The UPS function will be enabled automatically when no electric power is supplied.
The backup time of this system is 30 minutes.
- If no electric power is supplied, the device will stop automatically, emit an alarm, and flash a
red light. The user must take the device from the window as soon as possible.
- The user can recover the device by pulling from the safety rope. Pull lightly from the safety
rope at an angle close to the glass to prevent it from dropping.
Please, make sure the battery is fully charged (green light ON) before use
- Turn off the power switch on the device and plug it to the power supply. An orange light
turns on while charging.
- The green light turns on when fully charged.
Table-cleaning mode
- Put the device on the table and select the auto-cleaning mode, the device will use the tablecleaning
mode.
Notice
- For your safety, do not use the device on frameless widows.
- Make sure the cleaning ring is properly placed on the cleaning wheel to avoid leakage.
- For your safety, do not use in rainy or moist days.
- Set a danger-warning area downstairs for no-balcony windows and doors.
LED SIGNALS
The vacuum cleaner robot has been equipped with 3 indicator lights with different functions:
· The first light, to the left, signals the state of the battery. When the battery is low, incomplete, or charging,
the light will turn red. When the robot is fully charged, the light will turn blue.
· The second light is in the centre and signals when the robot starts cleaning. This light turns on
once the robot is already attached to the window and starts a cleaning mode. When the robot
is cleaning, the light will turn blue and blink.
· The third right, to the right, signals when the robot is in Stop/Pause mode. This light turns on
when the robot is attached to the window without cleaning, when the robot is in Stop/Pause
mode, or when the robot finishes the cleaning mode and stops. The light will turn red and blink