Marmitek MS13E Mode D'emploi page 6

manual MS13 05-12-2006
• Now press the <house/on> button the number of times that corresponds to the house-code that you
want to set. On the last press hold down the button (e.g. for house-code C press the <house/on>
button 3 times and hold the button down on the third press).
• After 3 seconds the LED will display the new setting. If you wait too long, or if an error occurs, the red
LED will flash rapidly. In this case no changes are implemented and you should start again from the
beginning.
PROGRAMMING THE UNIT-CODE
• Press the <unit/off> button and hold it down.
• The red LED will start to flash.
• 3 seconds later the LED will display the current unit-code setting (the factory setting is 1).
• 1 flash for 1.
• 2 flashes for 2.
• ...
• 16 flashes for 16.
• Release the <unit/off> button.
• Now press the <unit/off> button the number of times that corresponds to the unit-code that you want to
set. On the last press hold down the button (e.g. for unit-code 3 press the <unit/off> button 3 times and
hold the button down on the third press).
• After 3 seconds the LED will display the new setting. If you wait too long, or if an error occurs, the red LED
will flash rapidly. In this case no changes are implemented and you should start again from the beginning.
SETTING THE SENSOR FOR DAY/NIGHT USE
• Press the <unit/off> button once.
• The LED will flash briefly.
• Press the <house/on> button and hold it down.
• The green LED behind the PIR lens will light up.
• 3 seconds later the LED will display the current mode (the factory setting is 1).
• 1 flash when the motion detector is on during the day, light/dark sensor off.
• 2 flashes when the motion detector is off during the day, light/dark sensor off.
• 3 flashes when the motion detector is on during the day, light/dark sensor on.
• 4 flashes when the motion detector is off during the day, light/dark sensor on.
• Release the <house/on> button.
• Now press the <house/on> button the number of times that corresponds to the mode that you want
to set. On the last press hold down the button (e.g. for mode 3 press the <house/on> button 3 times
and hold the button down on the third press).
• After 3 seconds the LED will display the new setting and the LED will switch off.
SETTING THE DELAY TIME
(the length of time that the lamp will remain illuminated after the last motion has been detected)
• Press the <house/on> button once.
• The LED will flash briefly.
• Press the <unit/off> button and hold it down.
• The green LED behind the PIR lens will light up.
• 3 seconds later the LED will display the current mode (the factory setting is 1):
• 1 flash for 1 minute.
• 2 flashes for 2 minutes.
• 3 flashes for 4 minutes.
6
09:54 Pagina 6
© MARMITEK