Publicité
Les langues disponibles
Les langues disponibles
INSTALLING
THE SHOULDER
HARNESS
To avoid serious
WARNING:
personal
injury,
never attempt to start the unit when
standing
with the unit clipped to the
shoulder
strap. Always follow the starting
procedures
as described
in the Starting/
Stopping Instructions section.
1. Push the strap through the center of the buckle.
2.
Pull the strap over the cross bar and down through
the slot in the buckle (Fig. 7).
Attach Here for
Blowing
Attach Here for
Vacuuming
.
Fig. 8
While standing in the operating position, adjust the
length to fit the operator's size. Pull the tab to
lengthen, pull the strap to shorten (Fig 9).
Clip
.
Fig. 7
Snap the clip on to the support fittings on the front
or back of the handle. Clip to the front portion of the
handle when using the unit as a blower, and clip to
the back portion of the handle when using the unit as
a vacuum (Fig. 8).
Fig. 9
10
Publicité
