Opale-Paramodels Backpack XXS3 Mode D'emploi page 21

All manuals and user guides at all-guides.com
Before positioning the arm on the servomotor gear,
make sure that your servomotor is in the maximum
position up to + 100% (electronic stop and not me-
chanical)
Then insert the arm
in the low position -100%, the arm must be in this
position.
These new generation arms, offers a more consistent
debate, thus giving a better maneuverability to your
wing.
Then mount the two M3-30 spacers on the chassis
with a 3x8 CHC.
To attach the risers, use two M3 wide washers and
one M3x16 CHC.
The choice of the location of the spacers on the frame
is made according to the center of gravity of the
chassis when it's ready to fly.
The goal is to have a chassis with a plate horizontally.
To attach the risers, use two M3 wide washers and
one M3x16 CHC.
Brake adjustment:
Position the servomotors in the high position at
100%
Hold the chassis by the risers, and position the black
mark on the brake line at the same height as the ring
surrounded by heat shrink tubing. Arround this posi-
tion, the brakes will be almost correctly adjusted and
you ensure a minimum of control in flight. The brakes
will be adjusted with the next flight in order to have a
perfect settings and direct steering.
O p al e - Paramo d el s. co m
Opale Aero System SARL - 23 rue de la Motte
62250 MARQUISE - France
21
contact@opale-paramodels.com +33(0)981 144 387