tomado TDW6001S Manuel D'utilisation page 40

5. Fill the reservoir with salt until the overflow level.
6. Install the cap of the salt reservoir.
Caution:
Remove any spilled salt immediately and run a full program to prevent corrosion of the appliance.
SETTING THE LEVEL OF SALT CONSUMPTION
The salt consumption of the appliance depends on the level of water hardness.
Set the level of salt consumption according to the information in section
Note:
Contact your local water company to verify the level of water hardness in your area.
Note:
As a default, the level of water hardness of the appliance is set to level H3.
1. Push the on/off button to start the appliance.
2. Push and hold the program selector button within 1 minute after the appliance starts.
3. Push the program selector button again to change the level of water hardness.
4. Push the on/off button to confirm the setting.
FILLING THE DETERGENT RESERVOIR
Warning:
Store detergent out of reach of children in a cool and dry place.
Caution:
Only use detergent that is suitable for dishwashers.
Caution:
Do not put a detergent tablet in the cutlery basket, only use the detergent reservoir.
Note:
Detergent is available in powder, gel and tablets and is also available as a combined product (with salt and/or rinse
aid). Combined products only produce sufficient results under certain conditions. Observe the instructions of the
packaging.
1. Make sure that you fill the detergent reservoir before you start the appliance.
2. Push the latch (A) to open the detergent reservoir.
3. Fill the large reservoir (B) with detergent. For heavily soiled dishes you can also add detergent in the
smaller reservoir (C).
Caution:
The detergent reservoir has a capacity of 40 grams. Do not overfill the detergent reservoir. This can result in
poorly dissolving detergent and damage to your glassware.
4. Close the detergent reservoir.
5. Select a program.
6. Close the door.
40 • English
'Water hardness level settings (salt
(Figure 10)
consumption)'.
(Figure 11)
(Figure 12)