Klarstein LINDHOLM 10035362 Mode D'emploi page 16

EN
16
WALL INSTALLATION
Note: The product must be installed at least 15 cm from the floor and 50 cm from the
ceiling.
• Remove the bracket from the housing (Figure 1).
• Drill the holes on both sides of the wall and then insert the plastic expansion plugs.
Fasten the bracket to the wall with screws (picture 2).
• Move the heater to a suitable position so that the holes are level with the bracket
(Fig. 3).
• Tighten the screw at the top of the bracket to ensure that it is tight (Figure 4).
Freestanding
Mount the feet on the baseboard in accordance with below scheme.